Running Everything
Last updated
Was this helpful?
Last updated
Was this helpful?
After installing Python, Prometheus, Grafana, and downloading Yearn-Exporter.
If you haven't already downloaded yearn exporter, install , then find a place where you would like to put the exporter. In the address bar of that folder type cmd to open command prompt then type
Now your v1 exporter should be running. Open another command prompt in the yearn-exporter folder via the trick above and run
Now both v1 and v2 exporter should be running.
Find where Prometheus is installed at probably somewhere like the below directory
Once there best to run it prometheus from cmd to see any error/read them later. Open cmd anywhere then navigate to your prometheus install folder.
Next run
Navigate to the directory where you installed grafana most likely
open command prompt here
If you don't see any errors it should be up and running. You can check by visiting
If you set up the config correctly and yearn exporter is running you should see all green here
Now if everything we well grafana should be up and running at it will ask you to make a new password and just do that then you should be good to go to make your own custom yearn dashboard or add the premade ones how it's shown